Warrior 888 JK RENEGADE RACK AIR DAM (Universal) Manuel d'utilisateur télécharger pdf

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone (888) 220-6861

Fax (503) 692-0364

[email protected]

888 JK RENEGADE RACK AIR DAM

INSTALLATION INSTRUCTIONS

07-UP JK WRANGLER

Please read through the entire instructions before beginning. The 888 Renegade Rack Air Dam may be utilized to cut

down on wind noise generated by the Renegade Roof Rack System. It is mainly a bolt on kit, but it will require some drilling

through the two front angled dimple plates of the Renegade Racks’ front basket section.

KIT CONTENTS:

Description

Qty

Air Dam

5/16” Lock Washer

5/16” x _” Hex Bolt

5/16” Hex Nut

5/16” Flat Washer

INSTALLATION:

1. Begin by placing the air dam face down on a smooth surface then take a tape measure and measure the center-to-

center, hole width spread of the air dam mounting tab brackets. This distance should measure approx. 29.250”

between the two mounting tabs and 2.250” between the two holes on the tabs themselves. Some slight variance in

the manufacturing process is acceptable, so if your width measurement is different write it down and use that for the

proceeding steps.

2. Remove the front basket section of the Renegade Rack System for ease of accessibly during these next steps.

Looking at the front basket section of the Renegade Rack you will see two dimple plates that span the two horizontal

bars of the basket. Measuring from the outside of one of the dimple plates (doesn’t matter which) measure inwards

5/8” (.625) and draw a 2.5” long vertical line with a pencil. Next, measure from that pencil line, the center-to-center

hole spread distance of the air dam mounting tabs and draw another vertical pencil line on the other dimple plate.

Visualize the center of dimple and draw a horizontal hash mark through the vertical pencil line on both dimple

plates. Measure 1-1/8

(1.125”) both upwards and down from these hash marks giving a 2-1/4 (2.250”) vertical hole

spread. Mark these locations with a pencil then use a center punch to prepare for drilling.

1 2

888 JK RENEGADE RACK AIR DAM 1

Résumé du contenu

Page 1 - 888 JK RENEGADE RACK AIR DAM

Protecting Your Adventure Lifestyle========================================================================================QUALITY • INTEGRITY

Page 2

Protecting Your Adventure Lifestyle========================================================================================QUALITY • INTEGRITY

Commentaires sur ces manuels

Pas de commentaire

Warrior 888 JK RENEGADE RACK AIR DAM (Universal) Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Warrior 888 JK RENEGADE RACK AIR DAM (Universal). Warrior 888 JK RENEGADE RACK AIR DAM (Universal) User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Warrior 888 JK RENEGADE RACK AIR DAM (Universal)